Hifi音响
您现在的位置:hifi音响 返回上一页
BAT VK-255SEAmplifier
WARMTH OF TUBES, DYNAMICS OF SOLID-STATE The VK-255SE power amplifier represents Balanced Audio Technology’s hallmark out-of-the box approach to audio circuit design. Unlike most solid-state amplifiers that feature four or more gain stages in a high-

产品详情


BAT   VK-255SEAmplifier

立体声后级放大器

BAT_VK_255SE_Front_Silver.png



WARMTH OF TUBES, DYNAMICS OF SOLID-STATE

BAT_VK_255SE_Angle_Left_Silver.png

The VK-255SE power amplifier represents Balanced Audio Technology’s hallmark out-of-the box approach to audio circuit design. Unlike most solid-state amplifiers that feature four or more gain stages in a high-feedback push-pull configuration, the VK-255SE features only two gain blocks in a high-power, zero feedback, and purely symmetrical design. Available as either a stereo or monoblock unit, the VK-255SE has the warmth and texture typically associated with the finest vacuum-tube designs combined with the dynamic capability of the best solid-state offerings.



A ROBUST 300WPC PLUS SUPREME AUDIO SYMMETRY

BAT_VK_255SE_Inside_Silver.png

The VK-255SE’s elegant signal path follows Balanced Audio Technology’s purist approach of using zero negative feedback to achieve the design goals of wide bandwidth and circuit linearity. The whole amplifier circuit consists of just two gain blocks and is based entirely on N-Channel MOSFET devices. Assuring ultimate symmetry of the resulting signal, both sides of the waveform are handled by identical devices in identical circuit configuration. The VK-255SE offers a robust 300 watts per channel into a four-ohm load; the monoblock version doubles the current delivery of the stereo edition.




REVISED POWER SUPPLY EQUALS ENHANCED MUSICAL REFINEMENT

BAT_VK_255SE_Back_Silver.png

To complement the inherent simplicity of the VK-255SE’s fully balanced design, only the highest-grade parts are used throughout. The revised power supply incorporates the same second-generation oil-filled capacitors used in Balanced Audio Technology’s new REX II Preamplifier. They increase the high-quality filtering capacity, dramatically lower the noise floor, and present a grain-free, more refined portrayal of musical harmonics. Coupling speed and grace with an exquisite fidelity to the timbre and texture of instruments and voices, the VK-255SE markedly closes the performance gap between vacuum tube and solid-state amplification. It will serve as the anchor of any world-class system.



VK-255SEAmplifier

Output per channel at 8Ω/4Ω150W / 300WConversion to Mono?Factory Only
Output in Mono Configuration 8Ω/4Ω200W / 400WFrequency Response2Hz to 240kHz
THD at full power0.2%Input Impedance - stereo version100 kΩ
Input Impedance - mono version50 kΩGain (Nominal into 8Ω)26dB
Tube Complementn/aNumber of Power Cords1
Remote Control12V Trigger Input & OutputPower Consumption (Idle/Full Power)225W/1400W
Dimensions (WHD) Inches19" x 6.5" x 16"Dimensions (WHD) mm483 x 165 x 406
Weight75 Lbs